I needed to specify a particular MAC address in the 00:04 range. Valid values are between 00:50:56:00:00:00 and 00:50:56:3f:ff:ff.The reasons why VMware force manual MAC addresses into this scope are unclear to me (probably to prevent collisions), but regardless, it can be an issue.
The reason being we were retiring an old physical server running the FLEXlm licensing service and the licenses were granted for the MAC address of the NIC on that machine.
Page 1: Settings And Functions Replacement filters are available through blower you use. Your local Viking Range dealer, or you can call the Viking Online Store at Replace the bulb with a 120 volt, 50-watt 1-877-834-8222 or visit vikingrange.com halogen bulb.
Advertising
' (76.0 cm
)
15
'
(40
.0 cm)
+/- 3/
8'
(1.0
cm)
17
'
(43.8 cm)
16
'
(41.3 cm)
PRODUCT MODEL NUMBER
PRODUCT DIMENSIONS
VENTING DESIGN SPECIFICATIONS
Electrical: A 120-Volt, 60-Hz, AC-only, 15- or 20-amp electrical supply with
a fuse or circuit breaker. A time-delay fuse or time-delay circuit breaker is
recommended. It is recommended that a separate circuit serving only this
microwave oven be provided.
a fuse or circuit breaker. A time-delay fuse or time-delay circuit breaker is
recommended. It is recommended that a separate circuit serving only this
microwave oven be provided.
Microwave Hood Combination
Because Whirlpool Corporation policy includes a continuous commitment to improve
our products, we reserve the right to change materials and specifications without notice.
our products, we reserve the right to change materials and specifications without notice.
Dimensions are for planning purposes only. For complete details, see Installation
Instructions packed with product. Specifications subject to change without notice.
Instructions packed with product. Specifications subject to change without notice.
Ref. W10609724A
11/12/13
CABINET OPENING DIMENSIONS
12' (30.5 cm) min.
14' (35.6 cm) max.
14' (35.6 cm) max.
30'
(76.2 cm)
min.
A B
upper cabinet and
side cabinet depth
side cabinet depth
30'
(76.2 cm)
typical*
66' (167.6 cm) min.
A. 2' x 4' wall stud
B. Grounded 3-prong outlet
B. Grounded 3-prong outlet
The grounded 3-prong outlet must be inside the upper cabinet.
*30' (76.2 cm) is typical for 66' (167.6 cm) installation height.
Exact dimensions may vary depending on type of range/cooktop below.
WMH31017A
This section is intended for architectural designer and builder/contractor
reference only.
reference only.
NOTES:
●
Vent materials needed for installation are not provided with microwave hood
combination.
combination.
●
We do not recommend using a flexible metal vent.
●
To avoid possible product damage, be sure to vent air outside, unless using
recirculation installation. Do not vent exhaust air into concealed spaces, such
as spaces within walls or ceilings, attics, crawl spaces or garages.
recirculation installation. Do not vent exhaust air into concealed spaces, such
as spaces within walls or ceilings, attics, crawl spaces or garages.
For optimal venting installation, we recommend:
●
using roof or wall caps that have back draft dampers
●
using a rigid metal vent
●
using the most direct route by minimizing the length of the vent and number of
elbows to provide efficient performance
elbows to provide efficient performance
●
using uniformly sized vents
●
using duct tape to seal all joints in the vent system
●
using caulking compound to seal exterior wall or roof opening around cap
●
not installing 2 elbows together, for optimal hood performance
If venting through the wall, be sure that there is proper clearance within the wall
for the damper to open fully.
for the damper to open fully.
If venting through the roof, and rectangular to round transition is used, be sure
there is at least 3' (7.6 cm) of clearance between the top of the microwave oven
and the transition piece.
there is at least 3' (7.6 cm) of clearance between the top of the microwave oven
and the transition piece.
Roof venting
Roof cap
Wall venting
Wall cap
Page 1 of 2
Advertising
Popular Brands
Popular manuals
PAGE 1 OF 10
VIKING PUMP, INC.•A Unit of IDEX Corporation•Cedar Falls, IA 50613 USA
CONTENTS
The illustrations used in this manual are for identification
purposes only and cannot be used for ordering parts. Obtain a
parts list from the factory or a Viking® representative. Always
give complete name of part, part number and material with
model number and serial number of pump when ordering
repair parts. The unmounted pump or pump unit model
In the Viking model number system, basic size letters are
combined with series number (4195 and 495) are used to
indicate either an unmounted pump or mounted pump unit.
G, GG, H, HJ and HL4195 SERIES
Introduction. . . . . . . . . . . . . . . . . . . . . . . 1
Safety Information. . . . . . . . . . . . . . . . . . . . 2
Special Information. . . . . . . . . . . . . . . . . . . 3
Special Mechanical Seals. . . . . . . . . . . . . . . . 3
Pelgrim Mac 514 Rvs Turn Off Manual 2017
Maintenance . . . . . . . . . . . . . . . . . . . . . . 3
Disassembly . . . . . . . . . . . . . . . . . . . . . . 4
Assembly. . . . . . . . . . . . . . . . . . . . . . . . 7
Thrust Bearing Adjustment. . . . . . . . . . . . . . . 8
Pelgrim Mac 514 Rvs Turn Off Manual Download
Installation of Carbon Graphite Bushings. . . . . . . . 8
Pressure Relief Valve Instructions . . . . . . . . . . . 9
AS, AK and AL4195 SERIES
FIGURE 3
Unmounted Pump with Tapped Ports
Foot Mounted
unmounted pump model
indicating drive style.
G4195HL4195
H4195AK4195
Flange Mounted
G495HL495
H495AK495
This manual deals only with Series 4195 and 495 Heavy
Duty Pumps. Refer to Figures 1 through 14 for general
configuration and nomenclature used in this manual. Pump
specifications and recommendations are listed in Catalog
Section 144, Series 4195 and 495 Heavy Duty Pumps.
AS, AK and AL495 SERIES
Electronic copies of the most current TSM issue can be found on the Viking Pump website at www.vikingpump.com
SERIES 4195 AND 495